• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. F

    2013 DOOSAN G25P-5 with gm 2.4L on propane, no spark

    Bought a dead in water forklift. Anyone real familiar with these engines and common reasons it wouldn't have spark?
  2. F

    volvo ec210cl thumb quit working correctly

    The thumb has been working correctly but then quit while running it. It will now squeeze somewhat, but it will not raise up out of the way on its own. If you turn the thumb off, it will settle to the squeeze position almost immediately. I know the thumb circuit is somewhat complex on these...
  3. F

    Volvo EC210CL They sent wrong injectors. What is difference between labeled 'A' and 'B'

    We ordered 04290987 067 injectors which should have a big 'A' stamped on them. They instead sent us 04290986 067 injectors that has a large 'B' stamped on them. What does the A and B signify?
  4. F

    ec210cl injector crush washers

    The injectors have many different applications. Do the injectors need specific crush washers for each application or is the crush washer provided with the injector universal to all it's applications?
  5. F

    2008 volvo ec210cl runs great for 10 minutes then derates

    I got past the v-ecu 'no communication' for now. No yellow warning anymore. So, I can run it in auto mode for about 10 minutes digging and traveling, but then the red warning comes up to say shut down because of engine error. It derates 30 seconds or so later. It has to be left to cool...
  6. F

    volvo ec210cl gives red shutdown warning only at low idle

    This may not warrant a second thread, but I have a different main question. If this is bad manners on this forum, let me know. The above excavator asks us in red letters to shut it down in low idle but not at higher idle over 1700 rpm. The only code is a psid 209-09 communication but doesn't...
  7. F

    volvo ec210cl throttle dial won't work in manual. Code psid 201 09

    My volvo ec 210cl will not throttle up in manual mode. If you quickly switch it to auto mode and turn idle up over 1700 rpms it will usually idle almost indefinitely. But if you put it under load it will give you the red engine malfunction shut down screen and derate rpms. If you don't start...
  8. F

    joystick has to be squeezed to use hyd functions

    The genie 2506 I have which is very similar to a 5519 has a paddle button on the joystick that has to be squeezed in order to use the hyd functions. This is very uncomfortable and unhandy for me. Is there a way to disable this button. I tried taping it closed, but then the machine locks me out...
  9. F

    Genie 5519/2506 joystick functions

    My 2506 or 5519 has the joystick that the left thumb button is a slider. It controls the boom in and out. The other telehandlers we have and have used have the boom extend on the side to side motion of the joystick and thumb buttons for tilt. Can a person change around the wiring easily to make...
  10. F

    genie/terex 5519/2506 hyd function speed

    I just purchased a 2014 genie 2506 that is the same basic machine as a 5519. It doesn't have the knob to adjust hyd function speed, just a factory plug in the consul where the knob should be. For precise work, the speed is a bit fast. Can I install the control knob without much trouble? Is the...
Top