Hello, My name is Nate. This is my first real post here. I've read quite a bit over the years and there is a wealth of Information on this site. So Thank You. ![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
I have a 1985 710B with a weird leak. It is coming out of a hole in the Trans case just above where the Pressure Regulating Control attaches. I have taken some pictures that show the hole.
I was moving some piles yesterday and it stalled out going into a pile with the loader while in first gear. I was on the throttle pretty good and had some rear tires spin as I lifted the bucket through the pile while tilting back. Afterwards I re-started and when I backed up I saw a small puddle. I parked the machine and after cleaning everything off I found it was coming out of this hole. Using a mirror I was able to see in the hole today that there is the top of a spring inside it. I can not tell where the fluid is coming from.
When I started it today it didn't leak as bad but after a few minutes of work it left a circle about 6" in diameter.
Does it have something to do with the PRC? Is there a relief valve in there? To fix it will I need to drain the whole Trans?
The hole doesn't have any threads in it and i'm not sure if there is suppposed to be a plug or something in it.
Thank you for the help.
Nate
I have a 1985 710B with a weird leak. It is coming out of a hole in the Trans case just above where the Pressure Regulating Control attaches. I have taken some pictures that show the hole.
I was moving some piles yesterday and it stalled out going into a pile with the loader while in first gear. I was on the throttle pretty good and had some rear tires spin as I lifted the bucket through the pile while tilting back. Afterwards I re-started and when I backed up I saw a small puddle. I parked the machine and after cleaning everything off I found it was coming out of this hole. Using a mirror I was able to see in the hole today that there is the top of a spring inside it. I can not tell where the fluid is coming from.
When I started it today it didn't leak as bad but after a few minutes of work it left a circle about 6" in diameter.
Does it have something to do with the PRC? Is there a relief valve in there? To fix it will I need to drain the whole Trans?
The hole doesn't have any threads in it and i'm not sure if there is suppposed to be a plug or something in it.
Thank you for the help.
Nate
![imgp3275.jpg](/proxy.php?image=http%3A%2F%2Fimg851.imageshack.us%2Fimg851%2F5302%2Fimgp3275.jpg&hash=53800a60af43f5a4275da62325f4e01c)
![imgp3274y.jpg](/proxy.php?image=http%3A%2F%2Fimg192.imageshack.us%2Fimg192%2F5641%2Fimgp3274y.jpg&hash=a4756200b4d65515acd82aae22591a40)
Last edited: