hydraulic hammer is weak

[YAHYA]

Are you setting the relief to the hammer's operating pressure or setting it higher? Check the hammer's operating manual, it usually lists a relief valve setting, typically about 750-800 PSI higher than operating pressure. If its set at operating pressure you are constantly running the unit over relief.

Never trust that in-cab display, they are whack well over 90% of the time. Get a flow meter on the aux circuit to verify proper pressure/flow to hammer.

I get it byt its give me just 90 bar

 

[uffex]

Good day
Many hammers will not perform with a return filter, most bypass as these are expensive.
Kind regards
Uffex

 

[Kobelco ireland]

You might need to manually adjust the circuit relief pressure or swap over the relief valves on that circuit in case one is faulty

 

[Milos 123]

Hi I have same problem did you solved it ?