Grizzly Trucks

[diamondtguy]

I just ordered all the electronics for my tilt hood from Progressive Automations in Richmond BC. Shipping was only $16. All there stuff is made here...This will be interesting.

 

[Camshawn]

You couldn’t drive there for $16.

 

[diamondtguy]

You couldn’t drive there for $16.

Its coming from the USA via UPS...I may be in for a surprise..

 

[diamondtguy]

Last week when we were doing some air system up grades we found a bulk head fitting leaking on the outside. Obviously cracked. There are 3 in the cabinet along with a battery,cables, air lines and other stuff. Tight work space. I did get it changed today. It is the supply off of the air tank. I will air test it tomorrow. One more leak to find.. Yes the bulkhead fitting was cracked bad in more than one place.

 

[HarleyHappy]

The last pic, may not be a crack. If you look at machine made NPT fittings and others, you can usually find 4 witness marks. I always assumed this was because of the dies and however they were made.
First noticed in a Sun hydraulic block and thought they were cracks. Die tested them multiple times and they were not cracks.

 

[diamondtguy]

The last pic, may not be a crack. If you look at machine made NPT fittings and others, you can usually find 4 witness marks. I always assumed this was because of the dies and however they were made.
First noticed in a Sun hydraulic block and thought they were cracks. Die tested them multiple times and they were not cracks.

Yes....I saw those lines but they didnt go any where. Thanks

 

[diamondtguy]

New bulk head fitting installed and soap tested. All is good.One more leak to deal with and I know where it is...

 

[diamondtguy]

My electric actuators and all the components arrived today and more stainless hose and ends. I have work to do. No surprise on the actuator shipping. It was only $15.00