• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Kemper

  1. K

    MF5711 SL Service manual

    Goodeveing. Working on our farm tractor, Massey version 5711SL and having some emissions issues, I’ve narrowed it down to a rub wired from the DEF heater line. Currently have no ground but no schematic. Looking to see if someone has service manual and schematic! Thanks
  2. K

    D5k2 duo cone seal

    Yes please if you have it
  3. K

    D5k2 duo cone seal

    Thank you!
  4. K

    D5k2 duo cone seal

    So I was able to get that all done. Looking for procedure on removing final drive from D6K2 ground level final. My other guy has our computer so no access to procedure.
  5. K

    D5k2 duo cone seal

    Hello all, currently working on a duo cone seal on a D5K. I’m down to the part of separating the drive from the spindle and having issues separating it. Anyone done one on these and had luck? Went through procedure and it ends at removing gears. I assume it’s just the bearing that is holding it...
  6. K

    John Deere 624k

    Yes all at operating temp. Only test I have left to check is torque converter
  7. K

    John Deere 624k

    Thanks for all that! All pressures checked and within spec. Brake pedal was ok but lubricated to ensure wouldn’t stick. Where would we find clutch cutout? Customer has complaint of sluggish in first when pushing snow, but 2nd and 3rd will push it which I find weird.
  8. K

    John Deere 624k

    Oil Level is with in spec. No codes
  9. K

    John Deere 624k

    Hello everyone, doing an inspection on a 624k s/n 1Dw624kzlfd670526 Customer had complaint of sluggish in 1st gear and will barely push in first. Does anyone have a service breakdown on checking pressure before I dive in? Has not had a trans service in 4 years LOL. That’ll be my first stop
  10. K

    sevice manuals

    Looking for a hitachi zaxis 210LC service manual [email protected]
  11. K

    Linkbelt 225 spin ace potential purchase

    Just worked on them. I much prefer cat units
  12. K

    sevice manuals

    Looking for service manual for hitachi Zaxis 210lc
  13. K

    Linkbelt 225 spin ace potential purchase

    Check under hydraulic tank the main suction, seen a lot of the suck them selves in.
  14. K

    Hitachi 210 error codes

    Hey! Have a hitachi 210lc that we are working on. We replaced the dpf and within 2 hours codes were present 10026-00 and 10029-00 Now I’ve told that the dpf and diff pressure sensors were to be programmed to read properly to perform the first burn properly. Just confirming. We have never ran...
  15. K

    D6K2 frequent dpf problems

    Had soot level at 82% and within 3 hours with sitting at about 86%
See more
Top