Removing some fill and grading for a concrete slab at home and suddenly the back drag felt very weak and noticed the tilting felt strange. The hydraulic filter light started blinking and sometimes would be solid a couple hours prior so I figured maybe I had a clog? I planned on getting a new filter tomorrow anyway so I stopped for the night. Climbing out I noticed the right tilt cylinder was disconnected from the bucket pin. No biggie all it was is the pin rattled out due to the bolt breaking that holds the pin.
I started the machine to reattach the pin and the cylinder won’t extend. I didn’t try much diagnostic as the sun was coming down but I find it odd the cylinder wouldn’t extend out. The left cylinder seems to be doing all the work. I did just purchase this loader a couple months ago so it’s very new to me. Do I have a valve issue or a bad cylinder issue or? Where do I start? Thank you
I started the machine to reattach the pin and the cylinder won’t extend. I didn’t try much diagnostic as the sun was coming down but I find it odd the cylinder wouldn’t extend out. The left cylinder seems to be doing all the work. I did just purchase this loader a couple months ago so it’s very new to me. Do I have a valve issue or a bad cylinder issue or? Where do I start? Thank you