• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

shuttle

  1. outlawspeeder

    Case 580C 3rd and 4th gear

    I rebuilt the Shuttle Transmission and was expecting better out of 3rd and 4th gear. In 1st or 2nd it will climb a steep hill with a load but in 3rd or 4th it will it will barely get rolling... Is that normal for 3rd and 4th? I have to drive this about 7 miles (road mostly) and really don't...
  2. Troy4500Industrial

    Case 580B Dumping Trans Fluid

    Hey guys, can anyone point me in the direction to see what’s up? Trans pressure relief possibly? Just filled it yesterday woth new fluid, then today outta nowhere this happen. I have video of it dumping out but can’t get it on here. Takes a bit to start but when the tractor runs for say 30...
  3. J

    580B shuttle problems please help

    Excuse me if this is a repeat of a previous question asked. Good morning. Not really new here, have been reading posts for a couple years, but this is my first post. Having pretty much the same issues as others with these old 580b shuttles. Morning sickness, sluggish engagement or none when good...
  4. outlawspeeder

    580C Shuttle slipping? Fwd only

    My 580C is slipping in fwd gears. Reverse is good. Three days ago I pulled a 18 wheeler out of a ditch. Today I plowed the development I live in and its on a hill. Plowed uphill fine for three hours. The floor switch worked fine to disengage the clutch. At the end I was just clean up the...
  5. outlawspeeder

    580C Shuttle question

    I just got done wiring some of the 580C. Before this nothing powered was working. i.e. to start it was a jumper switch on the starter. I reinstalled a floor switch, wired in the switch on the dash,... Without it running I can step on the brake (switch on dash closed) or the switch on the...
  6. outlawspeeder

    580C Shuttle shift question

    So I think I might have a problem. This 580C has been sitting for over 10 years and I am getting it back to a usable state. Digging is strong. Bucket is strong. Brakes are good. Diff lock is good. It is like it is not strong enough to move itself. I know I am still getting use to how big...
  7. B

    Case CK 580B Shuttle Trans Dipstick question

    Hi, I just bought a 580B and am going through the usual fluid/filter flush and change. I found the loader hydraulic fill hole open (unplugged) and the Shuttle Dipstick tube (hole in floor in front of shifter) had only a cap on it not a dipstick. I did find a dipstick in the toolbox inside the...
  8. D

    580b shuttle leaking into transmission ?

    Hi all. new to the group found it looking for parts , So just purchased a 580b , rebuilt the brakes changes the transaxle oil and today noticed the level had increased from where I filled it to and it had a hint of red on it ? Is the shuttle leaking into the transaxle ? Is that a possibility ...
  9. C

    580b shuttle

    The shuttle wouldn't shift out of forward. I removed the shuttle and high/low shifter plate to find the spool for the forward and reverse had spun. Causing the lever not to shift the spool. My question is: Can I get the shifter plate and spool back together without splitting the backhoe? Thanks
  10. K

    580L shuttle slipping

    I have a '99 580L series II with the Carrero 4 speed transmission. Earlier this summer I noticed it starting to engage slowly in both forward and reverse after about a 5 mile road trip . I changed oil and filter and continued to use it. It became worse as it warmed up and especially if I ran it...
Top