• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. S

    Moving a Cat 15 miles

    Ńo roll backs there?
  2. S

    Hitachi Ex200-2 Pump At Full Swash - Stalling engine

    Test the solenoids again,the pvc only sends a flickering ground if you held continuous ground they may be fried also new doesn’t mean good any more
  3. S

    D5G parking brake won’t release

    Welcome to the gang! Got any codes?
  4. S

    Cat 931b lost forward and reverse trans fluid is filling into bevel gear any thoughts

    then if the clutch compartment is over full and pressure it can push past the one way seal to the bevel compartment ?
  5. S

    Dresser TD8E won’t move, driveshaft doesn’t spin

    What drives the winch rear of the input shaft?
  6. S

    Cat Excavator Suffix

    Don‘t know what it means but there is a few more out there
  7. S

    Caterpillar 302.5 Boom down/up pressure

    Dropping when you pull to raise and seeping down sounds like you have a leaking load check valve
  8. S

    Starter question

    Welcome to the forum!Sounds like you have twisted the bolt off the field coil,#11 in the middle pic
  9. S

    Excavator tracks weak turning

    If the swivel is bypassing the one in the air should move when you try to move the one on the ground
  10. S

    Excavator tracks weak turning

    Did you put one track in the air and try to move the one on the ground?
  11. S

    Hyd question

    Can’t limit the spool travel,fixed my lowboy ramps that way
  12. S

    Weld on hydraulic fittings

    No shop there that makes steel hydraulic lines ?
  13. S

    D3B Running Sporadically

    Should be a capped off tee in the line at the filter base for the gauge
  14. S

    D3B Running Sporadically

    You are talking about the screen in the fitting between the supply line and the lift pump?
  15. S

    Cat D6D track tensioner replacement and recoil tension spring lost preload

    I hope you have it fixed by now but I have one apart if you need me to measure something
  16. S

    Hitachi ex120-2 intermittent slow hydraulics for all functions.

    Stall a cylinder and see what the voltage is also I would try another volt meter 1/4 volt ain’t much
  17. S

    Hitachi ex120-2 intermittent slow hydraulics for all functions.

    Dave can’t he carefully backprobe the signal/middle wire on the p sensor read voltage key on not running
  18. S

    Hitachi ex120-2 intermittent slow hydraulics for all functions.

    Did you clear the codes and check the harness?
  19. S

    1988 Mack Superliner RW613 Tri-axle heavy hauler.

    I think coaldust cheated and looked at the pic in post 30 lol
  20. S

    Hitachi ex120-2 intermittent slow hydraulics for all functions.

    Yes you can get the codes by shorting two pins in the connector and counting the blinks on the led on top of the pvc ,I don’t remember which 2 you need the whole procedure from the manual. It is on here somewhere
Top