• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. D

    new holland lw230 transmission issues

    have a NH lw230 payloader that you can feel shift through the gears but in low gear (1ST) still acts as in second gear did speed test and verified that top speed is 2nd gear when lever is in 1st.... has no power to push into pile to get a bucket full.. anyone have any reccomendation what to...
  2. D

    case cx330 no/ limited swing, no right travel

    getting pilot pressure to each pump controller for sure??
  3. D

    installed new aftermarket pumps on john deere 330 clc help setting and thoughts

    Yes sure quality will show it but never know I guess haha about find out
  4. D

    installed new aftermarket pumps on john deere 330 clc help setting and thoughts

    And check pressure on monitor I’m guessing?
  5. D

    installed new aftermarket pumps on john deere 330 clc help setting and thoughts

    3/8- 1/2 inch out Id say on one that suppose be 3/16
  6. D

    installed new aftermarket pumps on john deere 330 clc help setting and thoughts

    All the setting are out further than the factory ones.. guy messed with them one setting I turned it back out the 1 turn now it hits the 30 second mark and way faster
  7. D

    installed new aftermarket pumps on john deere 330 clc help setting and thoughts

    i installed new aftermarket pumps on this deere 330clc and was curious if people know they are set close from factory as the little center screw on max flow is way out from the 3/16" book calls for but who know if that is same on these "china" pumps doing track speed test came up even between...
  8. D

    Is buying a 2005 JD160C to do land clearing/stumping too light of a machine???

    my thought is you be able do alot with machine looking/ thinking about but have think of how big or small of stumps gunna do with it obviously bigger machine is gunna be able do more work faster but smaller machine will be able do same type work at slower pace and more thought/precision within...
  9. D

    02 kobelco 210 dynamic acera engine pull down pump vibration p2 nega con

    thanks again ill switch wiring tomorrow and see what does.. sensor warning dont stay on all time is biggest problem so hopefully is when try in morning.. if it is on when start would i be able to swap wiring while running to help without messing something up or better off shutting off and...
  10. D

    02 kobelco 210 dynamic acera engine pull down pump vibration p2 nega con

    thanks so basically that tells pump to go into higher flow mode and could cause the vibration and stalling of engine if its telling pump to be kicked in even with pilot controll lever off??
  11. D

    02 kobelco 210 dynamic acera engine pull down pump vibration p2 nega con

    have a kobelco 210 that has a (( "b 12 se" p2 nega con sensor)) that started coming and going lately and at same time frame engine pulls down on idle like pump is still engaged with or without pilot lock on off (lever by seat for pilot control system) the first time happened was after...
Top