• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by eadams1998

  1. E

    Ferguson 35 roller throttle issue

    Replaced fuel filter and it was plugged fuel could only drip out slowly starts easy now but runs at close to full throttle now and still no control of throttle
  2. E

    Ferguson 35 roller throttle issue

    Have an older Ferguson 35 roller with the Waukesha vrd155A Diesel in it with a stanadyne pump on it and roller will start and go to full throttle then ease down to a low idle but I have zero throttle control can see the cable is pulling on the arm but no difference in rpm I can move the second...
  3. E

    Tb125 overheating issue

    upper hose is 180 area and lower hose is 150 area and Neither the radiator nor hyd cooler show any hot spots or hot temps both cool enough to hold a hand to them
  4. E

    Tb125 overheating issue

    With it in the red on the gauge only showing 210-217 at the thermostat housing at the hottest radiator is far cooler could it be a faulty temp sensor and is there a way to test it
  5. E

    Tb125 overheating issue

    Fan belt is tight checked coolant gasses with head gasket tester and no exhaust fumes present
  6. E

    Tb125 overheating issue

    Have also changed the radiator cap as well
  7. E

    Tb125 overheating issue

    06 area tb125 4400 hours problem with overheating have flushed radiator fins are clean oil cooler clean have the thermostat pulled and it will get near the red after light use rpm doesn’t seem to affect it seems to be hydraulic functions like tracking that heat it up the fastest
Top