• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. 2

    Needing to replace worn out rubber tracks

    Does anyone have any suggestions or advice where to get a decent buy on new rubber tracks for a Terex PT30, any help would be appreciated, TIA
  2. 2

    Terex PT30 hydraulic schematic needed

    I wanted to say thanks to you Arny for helping me diagnose my problem with no hyd pressure, it turned out the person I bought it from had the plastic coupler flywheel replaced awhile back and they installed it backwards and the tandem pump coupler gear teeth were only catching about 3/16" of...
  3. 2

    Terex PT30 hydraulic schematic needed

    Thank you Arny I'm trying that now
  4. 2

    Terex PT30 hydraulic schematic needed

    I have a feeling the safety soleniod is bad, I am getting 12v to it but I can't hear or feel it clicking when the 12v gets applied to it, and it gets very hot when 12v is left powered to it after a short time
  5. 2

    Terex PT30 hydraulic schematic needed

    Hey Arny I checked the solenoid coils at the control valve block under the foot area, and I am only getting 12v at the soleniod on the far right side, the other doubled stack soleniod coils I am not getting any voltage at them, should all 3 of these be getting 12v at the same time do you know ?
  6. 2

    Terex PT30 hydraulic schematic needed

    Thank you very much for your help and guidance it is much appreciated, I will check each one of those, I thought if the pump was turning then it would have pressure at least at the test port, can the pump be spinning and good and any of those items keep the test port from having any pressure, TIA
  7. 2

    Terex PT30 hydraulic schematic needed

    Thank you for the reply, I did check all of those and the tested good, I also jumped the pigtails to each of them just double sure, but I'm not getting any pressure at the control valve test port, any other suggestions would be greatly appreciated
  8. 2

    Terex PT30 hydraulic schematic needed

    Would anyone happen to have a hydraulic schematic in a PDF file that they will share, for a PT30, trying to diag a No hyd pressure to drive system and lift and tilt
  9. 2

    Starter wire locations

    I will try and get a better picture of the terminals on the front of the soleniod, also the white wire with the eyelet is to small to go over either of the 2 main starter bolts, maybe has a 3/16 eyelet hole, this is an after market starter so I'm not sure if the bolt terminals are the same size...
  10. 2

    Starter wire locations

    Can anyone help me with connecting the wires at the starter to the correct terminals, I purchased a 2013 PT30 that had the starter already removed, the white wire with the 1/4" eyelet with the yellow circle around it is the one I don't know where it goes, I know the other white wire with the...
Top